Voltronic Power SCC MPPT

This Enapter Device Blueprint integrates Voltronic Power SCC-MPPT Charge Controller. The Blueprint supports protocol over RS-232 communication interface.

This Blueprint supports visualization of the following metrics in Enapter Cloud and Mobile App:

• PV Input Voltage
• Battery Voltage
• Charging Current
• Charging Current 1
• Charging Current 2
• Charging Power
• Warnings and Errors

For detailed connection and operation instructions check Voltronic Power Website site.

Connect to Enapter

• Sign up to the Enapter Cloud using the Web or mobile app (iOS, Android).
• Use the Enapter ENP-RS232 or Enapter ENP-KIT-232-485-CAN communication module for physical connection.
• Add communication module to your site using the mobile app.
• Upload this blueprint to the communication module.

Physical Connection

For physical RS-232 connection with the inverter you will need:

• RS-232 communication module:
  • Either Enapter ENP-RS232 communication module,
  • Or ENP-KIT-232-485-CAN module (check out UCM Kit introduction and simple JLPCB ordering guide) + ESP-32 development board.
• Communication cable with RJ45 connector on one side and plain wires on another side. You can use RJ45 breakout connector to assemble such cable.

ENP-RS232 Connection Diagram

ENP-KIT-232-485-CAN Connection Diagram

Troubleshooting

This is initial version of the Blueprint. In case you find out any issues, please contact us in Discord.

References

• Voltronic Power Website